Installing an in-ground basketball hoop comes down to two jobs with a wait in between. First you dig a hole, fill it with concrete and set the anchor. Then, once the concrete has cured, you bolt the hoop to the anchor and raise it. For a Mega Slam system, the hole is 48 inches deep, the concrete cures for at least 72 hours, and each of the two work sessions takes about 90 minutes.
This guide walks through the full process in order, using the Mega Slam anchor method as the worked example. Hole sizes, hardware and assembly steps differ by brand and by model, so treat your own installation manual as the final word. Mega Slam manuals, videos and a list of local installers are on the Mega Slam installation page.

In-Ground Basketball Hoop Installation at a Glance
- Plan: choose the spot, check the overhang and have underground utilities marked by calling 811.
- Day 1: assemble the anchor, dig the hole, pour the concrete and level the anchor plate. About 90 minutes.
- Days 2 to 4: leave the concrete alone while it cures. Mega Slam requires a minimum of 3 days.
- Day 5: level the anchor nuts, mount the main pole and assemble the system. About 90 minutes with four adults.
Before You Dig: Planning and Preparation
Pick the Location
An in-ground hoop is a permanent structure once it is installed, so the location deserves more time than any other step. Look for a paved, smooth and level playing surface, as far from the street as your property allows. Keep the system clear of overhead power lines. Mega Slam manuals call for no overhead lines within a 20-foot radius of the hoop. Our guide on where to put a basketball hoop at home covers driveway and backyard layouts in more detail.
Account for Overhang and Setback
Overhang is the distance from the front of the main pole to the front of the backboard. It decides where the backboard ends up over your playing surface, so you need the number before you mark the hole. Mega Slam systems have overhangs from 3 to 5 feet depending on the model. See how basketball hoop overhang works if you are still deciding how much you need.
It is typical to set the concrete flush with the edge of the driveway, or up to 2 feet back from it, depending on how much playing space you have. On an adjustable system, leave a full 24 inches of open space behind the pole so you can turn the height adjustment handle.
Call 811
Call 811 a few days before you plan to dig. The call is free and is routed to your local One Call Center, which notifies the utility companies. Within a few days a locator marks the approximate position of buried lines, pipes and cables so you know what is below before a shovel goes in.
Tools and Materials You Need
The anchor kit, including the J-bolts, anchor plate and rebar, comes with a Mega Slam system. The manual lists these items as not included:
- Post hole digger and shovel
- Wheelbarrow or cement mixer, plus a garden hose
- Bagged concrete rated at 4,000 PSI or greater
- 2×4 lumber, six stakes, hammer and nails for the form
- Trowel, level and tape measure
- Two large crescent wrenches
Before you start, lay out the hardware and check it against the hardware list in your manual. If anything is missing, contact the manufacturer before you pour.
How Deep to Dig for a Basketball Hoop
Every Mega Slam in-ground system calls for a hole 48 inches deep. The width depends on the model. The Mega Slam 54, 60 and 72 and the FX 60 and FX 72 use a hole 20 inches by 20 inches. The Mega Slam XL and FX Pro use a hole 24 inches by 24 inches.
| Model | Hole size | 80 lb bags | 60 lb bags |
|---|---|---|---|
| Mega Slam 54, 60 and 72; FX 60 and FX 72 | 20 x 20 x 48 in | 20 to 22 | 27 to 30 |
| Mega Slam XL; FX Pro | 24 x 24 x 48 in | 27 to 29 | 36 to 39 |
Bag counts are for concrete rated at 4,000 PSI or greater.
Other brands publish their own footing depth and hole size, and some set the pole directly in the concrete instead of bolting it to an anchor. Do not carry a number from one hoop over to another. Use the figure in the manual for the system you bought.
One point applies to any heavy in-ground system: the footing has to be new concrete poured for the hoop. Mega Slam manuals state that the weight of the system does not allow it to be anchored to an existing concrete pad.
Step 1: Assemble the Anchor
Assemble the anchor before you mix any concrete, so it is ready to set the moment the hole is full. On a Mega Slam, you thread a nut onto each J-bolt, pass the bolts up through the holes in the anchor plate and tighten a second nut on top. Most models use four J-bolts. The XL and FX Pro use six. Your manual shows how far the bolts should stand above the plate for your model.

Step 2: Dig the Hole and Build the Form
Mark the hole so the anchor will sit square to the playing surface, then dig to the full depth and width in your manual. Build a simple square form from 2×4 lumber around the top of the hole and stake it in place. The form gives the footing a clean finished edge. Set the top edge of the form boards level with the playing surface.

Step 3: Pour the Concrete and Set the Anchor
Have all of the concrete on hand before you begin, because the footing has to be poured in one session. The table above gives the number of bags for each model.
Mix the concrete in a wheelbarrow or mixer and fill the hole about halfway. Work the concrete with a shovel or mixing rod so it fills the hole completely. Stand the rebar in the middle of the hole, spaced 6 to 8 inches apart. Then pour the rest of the concrete until it is flush with the top of the form boards, and smooth the surface with a trowel.

Set the assembled anchor into the wet concrete until the bottom of the anchor plate sits flush with the top of the finished concrete. Use a tape measure to confirm the anchor is square to the playing surface, and a level to confirm the plate is level front to back and side to side. For a look at this step in a real driveway, watch a Mega Slam 60 concrete anchor installation.
Step 4: Let the Concrete Cure
Allow the concrete to cure for a minimum of 3 days, or 72 hours, before any part of the system goes on the anchor. The installation timeline in the Mega Slam manuals puts the anchor on day 1 and assembly on day 5. This is the step people most want to shorten. Don’t.

Step 5: Level the Anchor and Assemble the System
After the cure, check that concrete or debris is not blocking the threads on the anchor bolts, then use a level to set the leveling nuts so the pole will stand plumb. Mega Slam anchors use J-bolts with self-leveling nuts, which let you fine-tune the system after the concrete has cured.

From here the assembly order depends on the model, so follow the manual step by step: main pole, extension arms, height actuator, backboard and rim. Plan on four adults. The glass backboard is a heavy lift, which is why Mega Slam calls for at least four people. Fixed-height FX systems use a hinge design, so the system is assembled with the backboard on the ground and then tilted up and locked in place without a mechanical lift. You can see the sequence in this Mega Slam 60 system install.
DIY or a Professional Installer?
Plenty of owners install their own hoop. The work is not complicated, but it is heavy: several hundred pounds of steel and glass, a 4-foot hole and 1,600 pounds of concrete or more. If you would rather hand it off, Mega Slam keeps a list of independent local installers by state. Mega Slam does not install systems itself. Because the job has two phases, expect an installer to make two visits. You can find an installer on the installation page.
One timing tip if you are hiring out or want the footing ready early: the anchor kit ships inside the main pole box, so it arrives with the hoop. If you want to pour before your system is delivered, you can buy an anchor kit separately on the parts page. The delivery information page explains how freight delivery is scheduled.
Common Installation Questions
How long does it take to install an in-ground basketball hoop?
About five days from first shovel to first shot, most of it waiting. For a Mega Slam, the anchor takes about 90 minutes, the concrete cures for at least 72 hours, and assembly takes about another 90 minutes.
How many people does it take?
One or two adults can handle the anchor and concrete. Mega Slam recommends four adults for assembly.
Can I take the hoop with me if I move?
With an anchor-mounted system, yes. The hoop unbolts from the anchor, and you set a new anchor kit in concrete at the new address. Our guide on how to move or remove an in-ground basketball hoop covers the details. More answers are in the installation FAQs.





